Siemens SIMATIC RF166C Operating Instructions Manual page 87

Table 7- 18
Displayed parameters
UID
Transponder type
Version
Lock status of the OTP
area
Size of the user memory Memory size of the user memory in bytes
Size of a memory block
Number of memory
blocks
Measured value power
flux density
Passive error counter
Active error counter
Presence counter
Error counter
The following error types are read and displayed:
Table 7- 19
Displayed error types
FZP
ABZ
CFZ
SFZ
CRCFZ
ASMFZ
Signal strength
AMLI
PMLI
SIMATIC RF166C
Operating Instructions, 03/2022, C79000-G8976-C578-02
Displayed parameters of the "Transponder status" area
Description
Unique identifier of the transponder
Transponder type (vendor, identification)
Version of the transponder chip
Disabled blocks of the OTP area on the chip
Size of the memory blocks of the transponder chip
Number of memory blocks of the transponder chip
Radiant power that arrives at the transponder.
The lower the value, the more power the transponder receives.
Number of passive errors which occurred
Number of errors which occurred
Sum of the signature and CRC errors
Time in [ms] that the transponder spent in the antenna field.
Error types displayed in the "Error counter" area
Description
Passive error counter
This error counter is an indicator for a disturbed environment
(interferences).
Abort counter
Counter for protocol errors on the air interface for which the transponder
aborted communication.
Code error counter
Counter for disruptions or collisions on the air interface that caused
communication to be disturbed.
Signature error counter
Counter for failed signature encryptions of written blocks of data. Only
relevant for the transponder type "RF300".
CRC error counter
Counter for failed CRC checks
Error counter for problems on the interface to the host (CM/PC)
Counter for errors on the serial interface
AM power indicator
Received signal strength [dB] for which amplitude modulation with the
transponder was detected.
PM power indicator
Received signal strength [dB] for which phase modulation with the
transponder was detected.
Configuration using the WBM
7.3 The menu items of the WBM
87