Error Codes - LinMot E1200-GP-UC Installation Manual

LinMot Installation Guide

7 Error Codes

Error Warn
Off Warning
On ● ~2Hz
0..15 x
Error Code
High Nibble
● ~2Hz ● ~2Hz
0..15 x
Error Code
High Nibble
● ~4Hz ● ~2Hz
0..15 x
Error Code
High Nibble
● ~0.5Hz ● ~0.5Hz
The meaning
Usermanual_MotionCtrlSW_SG5 and the user manual of the installed interface
software. These documents are provided together with LinMot-Talk configuration
software and can be downloaded from www.linmot.com.
®
NTI AG / LinMot
Error Codes
EN
Operation Normal Operation:
Enabled Warnings and operation enabled are displayed.
● ~2Hz Error:
0..15 x The error code is shown by a blink code with "WARN" and "EN".
Error Code The error byte is divided into low and high nibble (= 4 bit).
Low Nibble "WARN" and "EN" are blinking together.
The error can be acknowledged.
(e.g.: WARN blinks 3x, EN blinks 2x; Error Code = 32h)
● ~2Hz Fatal Error:
0..15 x The error code is shown by a blink code with "WARN" and "EN".
Error Code The error byte is divided into low and high nibble.
Low Nibble "WARN" and "EN" are blinking together.
Fatal errors can only be acknowledged by a reset or power cycle.
(e.g.: WARN blinks 3x, EN blinks 2x; Error Code = 32h)
● ~2Hz System Error:
0..15 x Please reinstall firmware or contact support.
Error Code
Low Nibble
On Signal Supply 24V too low:
The error and warn LEDs blink alternating if the signal supply +24V (X4.2) is
less than 18VDC.
of the error
www.LinMot.com
Description
codes can be found in the
Page 15/20