Table of Contents
Advertisement
Controller Series E100/200/400
Error codes
Error display When an error occurs it is displayed by means of the blinking of at least one of the four
LEDs on the front of the servo controller.
Ready LED The Ready LED is ON as soon as the supply voltage for the processor is guaranteed and
the system has started up correctly. Communication with the PC over the serial interface is only
possible when this LED is ON.
The following table summarizes the blink codes and their meaning:
F
LED
Fault
Stat A
~ 3Hz
off
2x
~ 1Hz
~ 1Hz
On
~ 2Hz
On
1x : Mot A
2x : Mot B
3x : Mot C
4x : Mot D
on LED is ON
off LED is OFF
Contact Addresses
NTI AG
LinMot
Haerdlistrasse 15
CH-8957 Spreitenbach
Schweiz
LinMot Inc.
5750 Townline Road
Elkhorn
WI 53121
USA
NTI AG
Stat B
HW system error: Hardware error in the servo controller.
off
SW1 System error: Software error in the servo controller. The system
software wasn't loaded successfully.
SW2 System error: Software error in the servo controller. The system
software wasn't loaded successfully.
~ 2Hz
Generic fault: The exact error message may be displayed
with the error inspector.
2x
The supply voltage for the Power circuitry is too low.
3x
The supply voltage for the Power circuitry is too high.
4x
The supply voltage for the Signal circuitry is too low.
5x
The supply voltage for the Signal circuitry is too high.
6x
The servo controller is too hot.
8x
Application Software Error (see manual)
1x
The motor is overloaded.
2x
The motor is too hot.
3x
Following error.
4x
The slider is missing from the motor.
6x
The initialization was not completed successfully.
7x
Incorrect motor type configured or damaged motor.
8x
A referenced motion profile for a motor is missing. Selected motion
profile not valid for actual drive type.
LED blinks shortly (ca. ¼s)
LED blinks longer (ca. 1½s)
Tel.:
+41 (0)56-419 91 91
Fax:
+41 (0)56-419 91 92
E-Mail: office@linmot.com
Web:
www.linmot.com
Sales:
877-546-3270
262-743-2555
Tech. Service: 877-804-0718
262-743-1284
Fax:
800-463-8708
262-723-6688
E-Mail: sales@linmot-usa.com
Web:
www.linnmot-usa.com
Installation: E100/E200/E400 series / 28.07.2010
Description
Page 12/12
Hide quick links:
Advertisement
Table of Contents
