Receiver Connections - Extron electronics Digital Video Transmitter and Receiver DVI 201 Rx User Manual

Extron electronics digital video transmitter and receiver user's manual

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

Installation and Operation, cont'd

Connect transmitter output 1 to receiver input 1.

Connect transmitter output 2 to receiver input 2.

If necessary, test for proper cable connection (output 1 to

input 1, output 2 to input 2) as follows:

Plug both TP cables into the powered unit.

Momentarily connect either of the cables on the

opposite end into the unpowered unit's "2" connector.

If the unpowered unit's Power LED is lit, the

connection is correct.

If the unpowered unit's Power LED is not lit,

unplug the connector on the unpowered end and

connect the other cable to the "2" connector.

See "TP cable termination," on page 2-23, to properly wire the

RJ-45 connectors.

Audio Output connector (DVI 201 A D Tx [Decora] only) —

Connect one end of a 5-wire audio cable to this 3.5 mm, 5-pole

direct insertion connector.

Connect the free end of the same cable from the transmitter to

any compatibly wired unit, such as a switcher, an amplifier, or a

DVI 201 A D Rx (Decora) receiver.

Figure 2-15 shows how to wire the captive screw audio

connector. Insert the wires into the appropriate openings in the

direct insertion connector. Tighten the screws on the side to

fasten the wires.

Unbalanced Output

NO GROUND HERE.

Tip

Sleeve (s)

NO GROUND HERE.

Tip

Figure 2-15 — Captive screw connector wiring for

transmitter audio output

Connect the sleeve to ground (Gnd). Connecting

the sleeve to a negative (–) terminal will damage the

audio output circuits.

DVI 201 Tx/Rx • Installation and Operation

2-18

Balanced Output

Ring

Tip

Sleeve (s)

Ring

Do not tin the wires!

Tip