Installation and Operation, cont'd
Final installation
After testing and making any adjustments, do the following:
1.
At the power outlet, unplug the power supply.
N
One power supply can power both the transmitter and
the receiver, so only one unit needs a power supply.
2.
Mount the transmitter or receiver into the wall box, and
attach the supplied Decora faceplate to the unit, as shown
in figure 2-11.
Wall Box
Wall opening
is flush with
edge of box.
Figure 2-11 — Mounting the transmitter or receiver
3.
At the power outlet, reconnect the power supply. This
powers up both units.
DVI 201 Tx/Rx • Installation and Operation
2-14
Decora
Faceplate
U T
IN P
D V
I
IN
D IO
A U
-2 32
R S
R U
TH
S S
Tx
PA
Rx
Extron
DVI 201 A D
Connections
Transmitter connections
The rack-mountable transmitter is in a quarter rack width
enclosure. The wall-mountable transmitter is in an enclosure
that can be mounted in UL standard wall boxes with Decora-
style face plates.
Figure 2-12 shows the front panel of both DVI 201 Tx models.
Figure 2-13 shows the rear panel of both models.
DVI 201 Tx Front Panel
DVI INPUT
1
DVI 201 A D Tx Front Panel
AUDIO L+R
3
RS-232
PASS THRU
4
Figure 2-12 — DVI 201 Tx front panel connectors
DVI 201 Tx/Rx • Installation and Operation
LOCAL OUTPUT
DVI 200 Tx Series
2
INPUT
DVI
1
Rx
Tx
2-15