Receiver Connections - Extron electronics DTP DVI 230 User Manual

Receiver Connections

POWER SIG LINK
12V
0.8 A MAX
DTP IN
Rear
11 7
Figure 3.
g
h
i
OVER DTP
RS-232 IR
Tx Rx G Tx Rx
10
DTP DVI 230 Rx Connectors
DTP Input RJ-45 connector — Connect one end of the TP cable from the transmitter
output connector to this RJ‑45 female connector. Ensure the opposite end of this cable
is connected to the transmitter DTP Out connector (see
ATTENTION: Do not connect this device to a telecommunications or computer
data network.
NOTE: See TP cable termination and recommendations
properly wire the RJ‑45 connectors and for detailed NOTES.
Signal LED — Indicates the unit is receiving a valid signal on the DTP In connector.
Link LED — Indicates a valid link is established between the units on the DTP input
and output cable.
DVI output connector — Connect a display with an DVI input port (or HDMI input
port, with an appropriate adapter) to display the transmitted direct digital image.
Audio output connector — This 5‑pole, 3.5 mm captive screw connector outputs
the transmitted, unamplified, line level analog audio. Connect an audio device, such as
an audio amplifier or powered speakers.
See figure 4 to properly wire a captive screw output connector. Use the supplied
tie‑wrap to strap the audio cable to the extended tail of the connector.
No Ground Here
Tip
Sleeves
Tip
Do not tin the wires!
No Ground Here
Unbalanced Stereo Output
Figure 4. Captive Screw Connector Wiring for Stereo Audio Output
ATTENTION: For unbalanced audio, connect the sleeves to the ground contact.
Do not connect the sleeves to the negative (‑) contacts.
NOTES:
• If you have removed the ground jumpers (see
page 11) because of ground potential differences, the DTP DVI 230 cannot
extend analog audio. No analog audio is output.
• The length of exposed wires is critical. The ideal length is 3/16 inch (5 mm).
• If the stripped section of wire is longer than 3/16 inch, the exposed wires
may touch, causing a short circuit.
•
If the stripped section of wire is shorter than 3/16 inch, wires can be easily
pulled out even if tightly fastened by the captive screws.
• Do not tin the power supply leads before installing them in the connector.
Tinned wires are not as secure in the connector and could be pulled out.
DTP DVI 230 Tx/Rx Transmitter and Receiver • Installation and Operation
DVI-D
Front
8
item
Tip
Ring
Sleeves
Tip
Ring
Balanced Stereo Output
Disconnecting the Ground
OUTPUTS
AUDIO
L R
DTP DVI 230 Rx
9
e
on the previous page).
on the next page to
on
5