Application Examples; Audio Conversion; Modulated Ir Pass Through - Extron electronics Digital Video Transmitter and Receiver DVI 201 Rx User Manual

Installation and Operation, cont'd

Application Examples

Audio conversion

Figure 2-28 shows a standard installation with DVI video and an
audio input. The DVI 201 A D Tx converts the video input into
two proprietary TP outputs. The Tx outputs the audio directly
on a captive screw connector.
MAX
OUTPUT
AUDIO POWER
R L
Figure 2-28 — Typical installation
DVI 201 Tx/Rx • Installation and Operation
2-32
0.4A
12V

Modulated IR pass through

Figure 2-29 shows an installation in which the Tx/Rx pair sends
a modulated infrared (IR) signal across the link. On the TX side,
control system is connected to the Tx pin (the modulated IR
signal) and the Gnd (signal ground) on the transmitter. An IR
emitter is connected to the Tx and Gnd receiver output.
Figure 2-29 — Installation routing modulated IR
DVI 201 Tx/Rx • Installation and Operation 2-33