Extron electronics Digital Video Transmitter and Receiver DVI 201 Rx User Manual page 16

Installation and Operation, cont'd
DVI 201 Tx Rear Panel
DDC ROUTE
POWER
REMOTE
12V
0.4A MAX
1
SPARE LOCAL
5
DVI 201 A D Tx Rear Panel
O
U
T
P
U
T
S
DO NOT
7
CONNECT
TO LAN
Figure 2-13 — DVI 201 Tx rear panel connectors
a
DVI input connector — Connect a DVI cable between this port
and the DVI output port of the digital video source. See "DVI
connector pin assignments," on page 2-22, for pin assignments.
b
Local output (DVI 201 Tx ([non-Decora] only) — If desired,
connect a DVI monitor for local monitoring of the input digital
image. See "DVI connector pin assignments," on page 2-22, for
pin assignments.
DVI 201 Tx/Rx • Installation and Operation
2-16
DVI 201 Tx
RS-232
PASS THRU
2 Tx Rx
6 4
DVI 201
1 A D Tx
6
2
5
N In a system where the local output is not used, ensure
that you power up the end display first before the video
source. Route the DDC to the remote end (see the
DDC Route DIP switch [item
page 2-29]).
c
Audio input (DVI 201 A D Tx [Decora] only) — Connect an
unbalanced stereo audio source to this 3.5 mm mini stereo jack
for unbalanced audio input. Figure 2-14 shows how to wire the
audio plug.
Tip (L+) Sleeve (Gnd)
Ring (R+)
Tip (L+)
Sleeve (Gnd)
Figure 2-14 — Audio input connector wiring
d
RS-232 connector — Connect a serial communications port to
this 3.5 mm, 3-pole captive screw connector for bidirectional
RS-232 communication. See "RS-232 connector wiring," on
page 2-26, to wire the connector.
N The RS-232 connector can also transmit one-way
modulated infrared (IR) signals. See "Modulated IR
pass through" on page 2-33.
e
DC power input connector — Plug the included external
12 VDC power supply into either this connector or the power
input connector on the receiver (item
"Power supply wiring," on page 2-25, to wire the connector.
f
Transmitter output connector — Connect one end of two
separate TP cables to these RJ-45 female connectors.
C Do not connect these devices to a computer data or
telecommunications network.
N In order to fit in the junction box, the TP cables and
RJ-45 connectors should not have a boot installed.
N Extron recommends 28AWG to 24AWG TP cable for the
RJ-45 connectors.
Connect the free ends of the same TP cables from the transmitter
to the receiver's Input RJ-45 female connectors (item
page 2-20).
DVI 201 Tx/Rx • Installation and Operation
b
, in "Operation", on
k
on page 2-21). See
h
on
2-17