Under-Desk Mounting - Extron electronics Distribution Amplifiers DVI DA4 Plus User Manual

Under-desk mounting

Mount the DVI DA6 Plus or DVI DA8 Plus (not shown) under
furniture, using the optional Extron MBU 149 under-desk
mounting kit (part # 70-222-01). Mount the DVI DA4 Plus using
the optional Extron MBU 125 under-desk mounting kit (part
# 70-077-01) as shown in the figure below. Follow the same
instructions with either kit:
Under furniture mounting the DVI DA4 Plus
To mount the unit under a desk or table:
1. If necessary, remove rubber feet from the bottom of the unit.
2. Secure the under-desk mounting brackets to the unit with the
four (DVI DA4 Plus) or eight (DVI DA6 Plus/DVI DA8 Plus)
provided #8 screws.
3. Hold the unit, with the mounting brackets attached, under
the furniture where it will be secured. Mark the position of
the holes on the underside of the furniture.
4. In the marked positions, drill four pilot holes 3/32" in
diameter and 1/4" deep.
5. Insert the four provided wood screws into the pilot holes
and tighten until approximately 1/4" of the screw head is
protruding.
6. Guide the holes of the mounting brackets over the
protruding screw head and slide the unit forward or
backward to seat it firmly under the furniture.
7. Tighten all four wood screws to secure the unit in place.
DVI DA Plus Series • Installation and Operation 2-5