Extron electronics DVI DA2 User Manual
Dvi & hdmi distribution amplifier
Hide thumbs
Also See for DVI DA2:
- User manual (30 pages) ,
- User manual (5 pages) ,
- Setup manual (2 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for Extron electronics DVI DA2
Summary of Contents for Extron electronics DVI DA2
- Page 1 User Guide DVI & HDMI DVI DA2 and DVI DA4 DVI Distribution Amplifier 68-1376-01 Rev. E 04 10...
- Page 2 Precautions Safety Instructions • English Warning Power sources • This equipment should be operated only from the power source indicated on the product. This This symbol is intended to alert the user of important operating and maintenance equipment is intended to be used with a main power system with a grounded (neutral) conductor. The (servicing) instructions in the literature provided with the equipment.
- Page 3 CAUTION: A Caution warns of things that might damage the equipment. WARNING: A Warning informs of things that might cause injury, death, or other severe consequences. Copyright © 2010 Extron Electronics. All rights reserved. Trademarks All trademarks mentioned in this manual are the properties of their respective owners.
-
Page 5: Table Of Contents
Contents Introduction ..........About the Manual......... 1 About the DVI DA2 and DVI DA4 ....1 DVI DA2 and DVI DA4 Features ....2 Installation ..........Installation Overview ........3 Front Panel Features ........3 Rear Panel Features........4 DVI Connections ........5 DVI Connector Pin Assignments .... - Page 6 DVI DA2 and DVI DA4 • Contents...
-
Page 7: Introduction
The Digital Visual Interface (DVI) Distribution Amplifiers (DAs) have one input and either two (DVI DA2) or four (DVI DA4) outputs. Output 1 for each model is for a local monitor and is used for Digital Display Channel (DDC) reference. -
Page 8: Dvi Da2 And Dvi Da4 Features
DVI DA2 and DVI DA4 Features External power supply — The DVI DA2 and DVI DA4 are powered by an external 12 VDC power supply (provided with the units). DVI-D input — Both distribution amplifiers accept one single link DVI-D input with a range of resolutions up to 1920 x 1200 or 1080p @ 60 Hz. -
Page 9: Installation
4), then turn on the display devices and input devices. Front Panel Features The front panels of the DVI DA2 and DVI DA4 are identical and shown in the illustration below. DVI DA SERIES DVI DISTRIBUTION AMPLIFIER Figure 2. -
Page 10: Rear Panel Features
DVI-D INPUT DVI-D OUTPUTS POWER 0.4A MAX LOCAL MONITOR Figure 3. DVI DA2 (top) and DVI DA4 (bottom) Rear Panels Power input — Connect the provided power supply to the 3.5 mm, 2-pole captive screw power receptacle. POWER Smooth Ridges 0.4A MAX... -
Page 11: Dvi Connections
Input connector — Connect the input signal to the female DVI connector. The DVI input signal is equalized to ensure integrity. Output connectors — Connect up to two (DVI DA2) or four (DVI DA4) DVI-D outputs to display devices, using the female DVI connectors. -
Page 12: Dvi Connector Pin Assignments
DVI Connector Pin Assignments The illustration below shows the pin assignments for the male and female DVI-I connectors. NOTE: Although DVI-I dual link connectors are used, the DVI DA2 and DVI DA4 are compatible only with single-link DVI-D video signals. -
Page 13: Operation
Troubleshooting section on page If there are any problems, consult DVI DA2 and DVI DA4 • Operation... -
Page 14: Troubleshooting
Display device shows a flashing black or blue screen, snow or other distortion — A device that is not HDCP compliant may be receiving HDCP-encrypted signals. The DVI DA2 and DVI DA4 are not High-Bandwidth Digital Content Protection (HDCP) compliant. They will pass HDCP-encrypted signals only to the local output device. -
Page 15: Reference Information
Connectors ........1 female DVI-I Video output Number/signal type DVI DA2 ......... 2 single link DVI-D (or HDMI*): 1 main, 1 local NOTE: Local output is used for DDC communications and hot plug detection. DVI DA4 ......... 4 single link DVI-D (or HDMI*) Connectors ........ -
Page 16: Part Numbers And Accessories
12 VDC 1.0 A Desktop power supply with Captive Screw connector 70-775-01 (1) IEC cord (4) Rubber feet (not attached) Setup Guide — DVI DA2 and DVI DA4 Optional Accessories Description Part Number DVID SL series male to male DVI-D patch cables... -
Page 17: Mounting
Mounting This section outlines the various mounting options available for the DVI DA2 and DVI DA4: Tabletop Placement Rack Mounting Under-desk Mounting Tabletop Placement Attach the four provided rubber feet to the bottom of the unit and place it in any convenient location. -
Page 18: Rack Mounting Procedure
To mount the scaler on a rack shelf, follow the instructions provided with the shelf accessories. Under-desk Mounting Mount the unit under a desk or podium, using the optional Extron MBU 125 under-desk mounting kit (part #70-077-01). Follow the instructions provided with the MBU 125 kit. DVI DA2 and DVI DA4 • Mounting... -
Page 19: Extron Warranty
In the event of malfunction during the warranty period attributable directly to faulty workmanship and/or materials, Extron Electronics will, at its option, repair or replace said products or components, to whatever extent it shall deem necessary to restore said product... - Page 20 +971.4.2991880 FAX Inside USA / Canada Only Inside Europe Only Inside Asia Only Inside USA / Canada Only +1.919.863.1794 +31.33.453.4040 +65.6383.4400 +86.21.3760.1568 +1.714.491.1500 +1.919.863.1797 FAX +31.33.453.4050 FAX +65.6383.4664 FAX +86.21.3760.1566 FAX +1.714.491.1517 FAX www.extron.com © 2010 Extron Electronics. All rights reserved.