Extron electronics DVI DA2 Setup Manual

DVI DA2 and DVI DA4 • Setup Guide
These instructions provide a quick setup guide for the Extron DVI DA2 and DVI DA4. Installation
and service must be performed by authorized personnel only. To install, cable, and power on
the DVI DA2 and DVI DA4, do the following.
Step 1 — Mounting
Install the DVI DA2 or DVI DA4 on a desk, or mount it under a desk or in a rack.
Step 2 — DVI Input/Output Cable Connections
Connect these cables, but do not power on the equipment yet:
• Connect a DVI cable from the Input connector to the video source device.
• Connect a DVI cable from the Local Monitor connector to the desired local output device.
• Connect DVI cables from the output connectors to the desired display devices.
Step 3 — Power Cable Connections
Connect the 12 VDC power supply to the power receptacle of the unit.
T
P U
IN
I- D
D V
R
W E
P O
V A X
1 2
A M
0 .4
Extron
DVI DA2
DVI Distribution
Ampli er
PC
POWER
12V
0.4A MAX
DC Power
Input
DC Power Cord
Captive Screw Connector
Ground
G
+12 VDC input
A 2
I D
D V
2
U T
T P
O U
I- D
D V
1
R
IT O
O N
L M
C A
L O
Local Monitor
Smooth Ridges
A
Power Supply
Output Cord
Ground all
Devices
External Power Supply
(12 VDC, 0.5 A max.)
Flat Panel
Display
A
SECTION A–A