Coating Materials List - Komatsu WA250-6 Shop Manual

SEN03851-01

Coating materials list

a The recommended coating materials such as adhesives, gasket sealants, and greases used for disas-
sembly and assembly are listed below.
a For coating materials not listed below, use the equivalent of products shown in this manual.
Cate- Komatsu
Part number
gory code
LT-1A 790-129-9030
LT-1B 790-129-9050
LT-2 09940-00030
790-129-9060
LT-3 (Set of adhesive
and hardener)
LT-4 790-129-9040
Holtz MH 705 790-129-9120
ThreeBond
790-129-9140
1735
Aron-alpha
790-129-9130
201
Loctite
79A-129-9110
648-50
LG-5 790-129-9080
LG-6 790-129-9160
LG-7 790-129-9170
LG-8
ThreeBond 419-15-18131
1207B
LG-9
ThreeBond 790-129-9310
1206D
4
50-100
Q'ty Container
150 g Tube
20 g Polyethylene
(2 pcs.) container
Polyethylene
50 g
container
Adhesive: 1 kg
Can
Hardener: 500 g
Polyethylene
250 g
container
75 g Tube
Polyethylene
50 g
container
Polyethylene
2 g
container
Polyethylene
50 cc
container
Polyethylene
1 kg
container
200 g Tube
1 kg Tube
100 g Tube
200 g Tube
100 General information on disassembly and assembly
Main features and applications
• Used to prevent rubber gaskets, rubber cush-
ions, and cork plugs from coming out.
• Used for plastic (except polyethylene,
polypropylene, tetrafluoroethylene and vinyl
chloride), rubber, metal, and non-metal parts
which require immediate and strong adhe-
sion.
• Features: Resistance to heat and chemicals.
• Used to fix and seal bolts and plugs.
• Used to stick and seal metal, glass, and plas-
tics.
• Used to seal plugs.
• Heat-resistant seal used to repair engines.
• Quick-setting adhesive.
• Setting time: Within 5 sec. to 3 min.
• Used mainly to stick metals, rubbers, plastics,
and woods.
• Quick-setting adhesive.
• Quick-setting type.
(max. strength is obtained after 30 minutes)
• Used mainly to stick rubbers, plastics, and
metals.
• Features: Resistance to heat and chemicals.
• Used for fitted portions used at high tempera-
tures.
• Used to seal various threaded portions, pipe
joints, and flanges.
• Used to seal tapered plugs, elbows, and nip-
ples of hydraulic piping.
• Features: Silicon-based heat and cold-resis-
tant sealant.
• Used to seal flange surfaces and threaded
portions.
• Used to seal oil pan, final drive case, etc.
• Features: Silicon-based quick-setting sealant.
• Used to seal flywheel housing, intake mani-
fold, oil pan, thermostat housing, etc.
• Features: Silicon-based, heat and cold-resis-
tant, vibration-resistant, impact-resistant seal-
ant.
• Used to seal transfer case, etc.
• Used for rough surfaces such as the circle
gear top seal which does not need to be
clamped, water resistance of the clearance at
the welded area, etc.
• Can be coated with paint.
Coating materials list
(Rev. 2009.02)
1
WA250, 250PZ-6