Removal And Installation Of Monitor Panel - Komatsu WA250-6 Shop Manual

SEN03859-00
Removal and installation of
monitor panel
Removal
k
Stop the machine on a level ground and set
the lock bar to the frame to fix the front and
rear frames.
k
Lower the work equipment to the ground,
stop the engine, apply the parking brake,
and put chocks under the tires.
k
Disconnect the cable from the negative (–)
terminal of the battery.
1. Pull out each switch from panel cover (1) on
the left side of the operator's seat and discon-
nect the following connectors.
(2): CN-L10
q
(3): CN-L11
q
(4): CN-L09
q
a Different specifications
switches and connectors.
2. Pull out each switch from panel cover (1) on
the right side of the operator's seat and discon-
nect the following connectors.
(5): CN-L19
q
(6): CN-L07
q
(7): CN-L08
q
(8): CN-L06
q
a Different specifications
switches and connectors.
2
50-800
3.
1
4.
use different
use different

Removal and installation of monitor panel

Remove 8 mounting bolts (1a) and panel cover
(1).
Remove 2 pieces (9) and 1 piece (10) of the
monitor panel mounting bolts.
800 Electrical system
[*1]
[*2]
WA250, 250PZ-6