WARNING:
The Source 4WRD LED is not user serviceable. Field
•
modification of the Source 4WRD LED will void your ETC
warranty.
Do not use the fixture below 5°C (41°F).
•
Minimum storage temperature is 5°C (41°F). When the
•
fixture has been stored or transported in cold
temperatures, allow it to warm to room temperature
for a minimum of 1 hour before applying power.
Applying power to a cold fixture will cause damage to
the fixture and void the ETC warranty.
Do not use this fixture if a glass lens is deeply scratched
•
or cracked. Damaged lenses must be replaced.
To prevent wiring damage, or abrasion, do not expose
•
wiring to edges of sheet metal or other sharp objects.
Use the fixture in dry locations only, where humidity
•
does not exceed 90 percent (non-condensing). These
fixtures are not intended for outdoor use.
Do not make or alter any open holes in an enclosure of
•
wiring or electrical components during kit installation.
Note:
LUMINAIRE WHERE THE SUITABILITY OF THE COMBINATION SHALL
BE DETERMINED BY AUTHORITIES HAVING JURISDICTION.
Specifications
For full product specifications, see the Source 4WRD PAR and PARNel
datasheet at etcconnect.com.
Weight
Source 4WRD PAR fixture body only: 2.83 kg (6.25 lb)
•
Assembled Source 4WRD PAR fixture: 4.53 kg (9.98 lb)
•
Source 4WRD PARNel fixture body only: 3.49 kg (7.70 lb)
•
Assembled Source 4WRD PARNel fixture: 5.18 kg (11.43 lb)
•
Source 4WRD Installation and User Manual
Note the following warnings before use:
THE RETROFIT KIT IS ACCEPTABLE AS A COMPONENT OF A
5