ETC Source 4WRD Installation And User Manual page 20

Clean the Reflector
WARNING:
clean the reflector.
AVERTISSEMENT :
refroidir avant de nettoyer le réflecteur.
To quickly clean the reflector, remove the lens (see
page 13
or
from the reflector with a blast of oil-free air. You may also wipe the
reflector with a clean lint-free cloth. If either method is not sufficient,
follow these steps.
1. Remove the lens. See
PARNel Front Lens on page 14
2. To protect the Source 4WRD LED during cleaning, remove the LED
housing by loosening the attachment screw and pulling the LED
housing straight out. See image on
3. Remove any dust with a blast of oil-free air or wipe with a clean,
lint-free cloth. You can use isopropyl alcohol, distilled water, or a
50%-50% mixture of each to clean the glass surface.
4. Replace the lens. See
PARNel Front Lens on the previous page
5. Reinstall the Source 4WRD LED and tighten the attachment screw.
Install the Source 4WRD LED on page 6
See
16
Unplug the fixture and allow it to cool before you
Débrancher le projecteur et le laisser
Remove a PARNel Front Lens on page 14
Remove a PAR Lens on page 13
.
page 6
Install a PAR Lens on page 13
Source 4WRD Installation and User Manual
Remove a PAR Lens on
) and clean the dust
or
.
Install a
or
.
.
Remove a