ETC Installation Guide
ColorSource PAR v1.7/v3.0
Safety
For professional use only. Read the entire manual before using this
equipment.
WARNING:
Risk of eye injury. Do not stare directly into the light.
•
Do not mount the fixture on or near a flammable surface.
•
When the fixture is mounted, the axis between the yoke
•
attachment points must be parallel to the ground. Mounting
the fixture in a non-parallel orientation risks property
damage or bodily injury.
Disconnect the fixture from power and DMX and allow it to
•
cool before installing accessories or performing any cleaning
and maintenance.
AVERTISSEMENT :
Risque de lésion oculaire. Ne fixez pas directement la
•
lumière.
Ne pas installer le projecteur sur ou à côté d'une surface
•
inflammable.
Lorsque le luminaire est accroché, l'axe entre les points de
•
fixation de la lyre doit être parallèle au sol. Le montage du
luminaire dans une orientation non parallèle risque de
causer des dommages matériels ou corporels.
Débranchez le projecteur de son alimentation et du DMX et
•
laissez-le refroidir avant d'installer des accessoires ou
d'effectuer un nettoyage ou un entretien.
WARNING:
Luminaire suitable for use in emergency lighting applications in
accordance with 2017 National Electrical Code section 700.24
when used with an ETC DMX Emergency Bypass Controller.
Equipment intended for this purpose must be properly selected,
installed, and maintained so that facility conformance can be
obtained. Installation and servicing shall be performed by
qualified service personnel.
ColorSource PAR
The ColorSourcePAR is a Directly Controlled
Page 2 of 16
ETC