Dynalink ADSL2+ Wireless VoIP Router RTA1046VW User Manual page 27

Method Two – Run a silent installation.
Copy the USB driver folder from the driver CD to somewhere on the PC. (In
our example, the driver files are put under D:\Askey ADSL USB WHQLed.)
Open Start menu, key in cmd in the blank and press enter. Then click cmd.
2
1
When the Command Prompt screen appears, point to the driver folder on
your PC, and then enter setup -s. Press enter to start silent installation.
The system will install the driver automatically. You can connect your router
and the PC with a USB cable now.
The system will detect the USB driver automatically.
Note: If the USB device is not detected, check the USB cable between the
PC and the device. Also make sure that the device is power on.
After the file copying finished, a completing message will appear.
You can use the router now.
Chapter 2: System Requirement and Installation
13