Voice Over Ip Features; Atm Features - Dynalink ADSL2+ Wireless VoIP Router RTA1046VW User Manual

Voice over IP Features

ATM Features

1
T.38 fax relay can be supported on demand.
64-bit or 128-bit key length
Support 802.1x and WPA/WPA2
Support the Access Control function: only registered WLAN clients are allowed
to associate to this device.
SSID can be hidden for the security issue (Don't broadcast SSID).
Two SSIDs are supported currently. One SSID can be used for main wireless
network and the other SSID can be used for guest wireless network. Two
wireless networks can be configured in different wireless security level
Support the Repeater function to extend the coverage area
Support wireless user isolation for the hotspot
Call Feature: basic outgoing and incoming call, Call Waiting, Three Party
Conference, Call Transfer, Caller ID
Call Control: support MGCP (RFC2705) or SIP (RFC3261)
Voice Transport: compliance to RTP (RFC1889)
Voice Codec: G.711 (a-law and u-law), G.726, and G.729A
Tone/Ring Signal: compliance to North America, UK, France, Netherlands,
Germany, Switzerland, etc.
Tone Generation: support dial tone, ring back tone, busy tone, ring tone, and
various tones on demand
Tone Detection: support DTMF
Echo Cancellation: compliance to G.168
Support RFC2833 RTP Payload for DTMF Digits, Telephony Tones and
Telephony Signals
Support RFC3842 Voice Message Waiting Indication
Two VoIP (FXS) ports for VoIP phone calls
Both VoIP ports supporting intelligent lifeline backup
Manual selection of PSTN mode or VoIP mode while making a phone call
Automatic selection of PSTN phone call on dialing the emergency calls
Traffic flow control to guarantee voice quality
Support FAX/Analog Modem function
Support T.38 Fax relay
Compliant to ATM Forum UNI 3.1 / 4.0 Permanent Virtual Circuits (PVCs)
Support up to 16 PVCs for UBR, CBR, VBR-nrt, VBR-rt with traffic shaping
RFC2684 LLC Encapsulation and VC Multiplexing over AAL5
RFC2364 Point-to-Point Protocol (PPP) over AAL5
RFC2225 Classical IP and ARP over ATM
RFC2516 PPP over Ethernet: support Relay (Transparent Forwarding) and
Client functions
1
Before You Use
xi