Table of Contents
Advertisement
58
Smart Shop "M" Maker 2 - 3 Phase Power
Maintenance & Trouble Shooting
The Smartshop M uses Linear Guide Rails, Ball Screws, and Ball Bearings. These need to be lubricated
periodically (Once a Week). Each Axis has 2 Guide Rails each. Keep machine free of the products chips & debris.
**Note: Do to leave Spindle in the Tool for a prolonged period of time (Spindle could Rust into the tool
over time). Make sure to remove Spindle from Tool after being used.**
Schedule & Document into ones Preventive Maintenance Program (Per Any ISO/QS/TS Standards): Once a week,
if the machine is used Daily.
A Visual Inspection is always recommended. If the rails are dry to the touch, then get an oil can and a rag.
Any 30WT Motor Oil or White Lithium Grease is recommended.
Advertisement
Table of Contents
