Machine Placement - laguna Smart Shop M2 Owner's Manual

Machine Placement

Your machine will likely be delivered by a third party delivery service. Before unpacking your new machine, first
inspect the packaging, the invoice, and the shipping documents supplied by the driver. When unpacking your
machine, separate all enclosed items from the packing materials and inspect them for damages. Ensure that there
is no visible damage to either the packaging or the machine BEFORE the driver leaves. Save all packaging
materials until you are satisfied with the machine and/or have resolved any issues concerning any missing or
damaged items.
NOTICE!
All shipping damage must be noted upon delivery and signed by the owner and the delivery driver. If you
find any damaged items in your package, you must contact Laguna Tools to file a complaint. In order to return
damaged goods under the limited warranty to Laguna Tools, Inc., you MUST have the original packaging. All claims
of loss or damaged goods must be reported to Laguna Tools within 24 HOURS of delivery. Please contact the
Laguna Tools, Inc. Customer Service Department to make claims for any damaged items/parts.
NOTICE!
It is probable that you will find sawdust within your machine. This is because the machine has been
tested prior to shipment from the factory and or Laguna Tools. We test machines prior to shipping to customers,
but movement can take place during transportation. Some adjustments may have to be undertaken by the
customer. These adjustments are covered in the various sections of this manual.
PLACEMENT:
Before you remove your machine from the packaging, select the area where you will use your
machine. There are no hard and fast rules for its location, but below are a few guidelines:
1. There should be sufficient area at the front of the machine to allow you to work on it comfortably.
2. There should be sufficient area at the back of the machine to allow access for adjustments and maintenance to
be conducted.
3. Adequate lighting. The better the lighting the more accurately and safely you will be able to work.
4. Solid floor. You should select a solid flat floor, preferably one made of concrete or something similar.
5. Locate it close to a power source and dust collection.
6. Allow an area for the storage of blanks, finished products and tools.
LOCATING YOUR MACHINE:
safe assembly and operation of your machine. Before removing your dust collector from the packaging consider the
weight load, electrical installation requirements, lighting, dust collection, and space allocation available for the band
saw and accompanying materials.
SPACE ALLOCATION/DUST COLLECTION:
materials which will be processed through your machine. Leave ample around the machine for the operator to
handle both the equipment and the materials begin cut. Leave enough space around the machine to open or remove
doors/covers as require by the maintenance described in the owner's manual. Allow enough space for proper dust
collection from your machine. For optimal operation, ensure that your machine is located in a dry environment free
from excessive moisture, extreme weather conditions, hazardous chemicals, or airborne abrasives.
ELECTRICAL REQUIREMENTS:
voltage required to operate your machine. Ensure that all power cords are protected from traffic, moisture,
chemicals, or other hazards. For you safety, have a qualified electrician assess your electrical needs and grounding
if you have any doubts about your own ability to do so. We
to supply power to your machine
The physical environment where you locate your machine is important for
Place your machine near an existing power source with the appropriate
.
Smart Shop "M" Maker 2
Consider the largest size and length of wood or other
DO NOT
recommend that you use an extension cord
21