laguna Smart Shop M2 Owner's Manual page 43

Smart Shop "M" Maker 2 43
i.It may be helpful to use a sheet of paper by sliding it back and forth under the bit, while jogging the z-axis down.
ii.Once the paper is snagged by the bit you know one is within a paper thickness (0.1mm) of your material.
iii.Must set by using Tool #1.
b.) Press the ZC-->0 button.
c.) On the controller, you will see the Z-axis coordinate go to zero (Figure #1).
d.) (Optional) Press REF/OK Button x2 (Twice).
Pressing REF/OKis simply moving to the Origin position.
e.) This will retract the spindle to a safe starting location.
f.) Put on your SAFETY GLASSES and run the program Turn "On" Dust Collector & Table Vacuum & ensure your
material does not move.