laguna Smart Shop M2 Owner's Manual page 40

40 Smart Shop "M" Maker 2 - 3 Phase Power
**Note: Tool 1 is needed, because Tool 1 is the Master Tool Bit.**
Figure #1-Control Screen after Loading Program and Setting Work Origin.
Jog the spindle to the "Program's Origin Point". This is determined by the CNC Program that was previously
created.
a.If you are using Vectric's V-Carve/Aspire Software, it is called the "XY Datum Position".
b.Once the spindle is in position Press the XY-->0 Button to set the "XY Origin Point".
c.On the controller, you will see the X and Y axis coordinates go to Zero (Figure #1).
UP Y+, and Down Y-Buttons. Right X+, and Left X-Buttons.