KERN FCD 10K-3 User Manual page 23

hi
1. If the weighed portion is above the upper limit value, the
2. If the weighed portion is below the upper limit value, the
low
1. If the weighed portion is below the lower limit value, the
2. If the weighed portion is above the lower limit value, the
3. Confirm the selection by pressing
The window for value entry in the numerical form will be displayed where you
can enter the lower limit value. The tolerance symbol
active item is blinking.
4. Enter the lower limit value (for entering the numerical value see chapter 3.2.1)
and confirm.
5. < > will be displayed for a while. The window for value entry in the
numerical form will be displayed where you can enter the upper limit value. The
tolerance symbol
6. Enter the upper limit value (for entering the numerical value see chapter 3.2.1)
and confirm.
7. < > will be displayed for a while, the scale will switch to the weighing mode
again.
Tolerance check start:
 Ensure the test weighing mode is active. To do it, press TARE and hold it long
enough for <
 Place the weighed material (< 20 d) and, based on the tolerance symbols / audible
signal, check if the weighed material belongs to the preset tolerance range.
Weighed material
below
the preset tolerance
• To cancel the limit values, enter <00000.0 kg>.
• Deactivate the test weighing mode. To do it, press TARE and hold it long
enough for <
TFCD_A-BA-e-2110
sound is heard and the tolerance symbol OVER is
displayed.
sound is not heard and the tolerance symbol UNDER is
displayed.
sound is heard and the tolerance symbol UNDER is
displayed.
sound is not heard and the tolerance symbol OVER is
displayed.
, <
will be displayed, the active item is blinking.
> to be displayed.
Weighed material
in the preset
tolerance range
> to be displayed.
> will be displayed for a while.
will be displayed, the
Weighed material
above
the preset tolerance
23