Advertisement
NIEUPORT 28
C. Tail Assembly.
1. Before you start to build the horizontal stabilizer assemblies you will need to soak the balsa strips in water before bending to the shape shown on
the plan. We recommend that you cover this part of the plan using clear food wrapping film and scotch tape before pinning the balsa down in the
required shape as it dries out, this will keep the plan clean and dry. Once the balsa strip is dry, assemble the structures in the sequence shown.
Check the fit of each part and sand as necessary before glueing into place. Keep the assemblies pinned down until fully dry to stop twisting or
warping of the structures.
29
Advertisement
