Advertisement
NIEUPORT 28
8. Trial fit the horizontal stabilizer to the fuselage to the position shown on the plan. Sand as necessary to achieve a good fit and to ensure it is
square and level to the fuselage. Once satisfied with the fit, glue into place using a good slow setting epoxy, ensure it remains square and level
as the glue sets. Note: You may wish to cover the model with your choice of covering before glueing the stabilizer into place.
9. Mark the screw location on the stabilizer saddle so that they align with the screw holes in the rudder base block. Drill the two 3mm holes and
screw the fin/rudder assembly into place using the supplied 3mm screws.
32
Advertisement
