Advertisement
NIEUPORT 28
4. Trial fit then glue the trailing edge into place.
Use a mediun CA glue and ensure it is pinned
or held in place as the glue sets. When the CA
has set run some epoxy glue around the joints
to add strength.
5. Install the wood blocks between the ribs as
shown, sand as necessary to ensure a good fit.
6. Glue the 6x8mm Paulownia strips to the front spar. Drill two 3mm holes in the spar in the
positions shown on the plan. Install four blind nuts and secure using epoxy glue.
35
Advertisement
