Advertisement
NIEUPORT 28
D. Wing Center Section Assembly.
1. Before you start to build the center section, as
before, you will need to soak the balsa strips
in water before bending to the shape shown
on the plan. Again as mentioned before, we
recommend that you cover this part of the
plan using clear food wrapping film and scotch
tape before pinning the balsa down in the
required shape as it dries out, this will keep
the plan clean and dry.
2. Once the balsa strip is dry, assemble the
structure in the sequence shown. Check the
fit of each part and sand as necessary before
glueing into place, use pins and clamps to
hold things together as the glue dries. Keep
the assembly pinned down until fully dry to
stop twisting or warping of the structure.
34
3. Assemble the wing ribs to the spar to form
the center section as shown.
Advertisement
