Connecting The Valve Control Line - Xylem WTW MIQ/CHV PLUS Operating Manual

Installation
3.4
General instal- Observe the following instructions when attaching connecting wires to the termi-
lation instructions nal strip:
 Shorten all the wires used to the length required for the installation.
 Basically, fit all stranded wire ends with wire end sleeves before connecting
 Any wires that are not used and project into the housing must be cut off as
Materials required  Wire end sleeves, suitable for the connecting wires, with suitable crimping
 1 x cable gland with sealing ring (scope of delivery MIQ/CHV PLUS)
Tools  Cable stripping knife
 Wire stripper
 Phillips screw driver
 Small screw driver
12
All manuals and user guides at all-guides.com

Connecting the valve control line

The valve control line must be connected if the valve is not
controlled via the IQ S
them to the terminal strip.
closely as possible to the cable gland.
tool
WARNING
Danger of injury from lines that are under pressure. Before
opening the compressed air line, ensure that the section
of line concerned is free of pressure. The compressed air
glands in the housing may only be opened by a service
technician authorized by WTW.
N system.
ENSOR ET
ba75539d03
MIQ/CHV PLUS
03/2018