Vri Main Panel Wiring; Vri For Pivot Control, Non-Zimmatic Main Panel Wiring - Lindsay GROWSMART Installation Manual

VRI Main Panel Wiring

VRI for Pivot Control, Non-Zimmatic Main Panel Wiring

NOTE: For VRI panel control of system end guns, the VRI software
I/O Settings must be set to Output "OUT2" for End Gun 1, and Out-
put "OUT3" for End Gun 2. If VRI panel control of end guns is not
desired, use software settings of "Disabled" for both end gun outputs,
leave standard main panel to collector ring wiring for the end gun(s),
and cap off the unconnected purple and tan wires of the VRI panel
cable with wire nuts for safety.
P/N 1600043 Rev M (ECN 34095) 18 VRI Installation Manual