Table of Contents
Advertisement
Oxygen distributor
Different versions are available either for connection to a
pipeline system or an oxygen cylinder.
Suspend the oxygen distributor from the standard rail.
Connect the oxygen supply.
Connect the oxygen load.
Oxygen monitor, e. g. Dräger Oxydig
Fasten Oxydig onto the compact rail, with its holder.
Turn Oxydig such that the control panel of the measu-
rement unit faces the front.
Place the oxygen sensor in the cot.
Feed the cable through the flexible hose seals on the
front side. Plug the sensor's plug into the
measurement unit.
Prepare and use Oxydig in accordance with the rele-
vant Instructions for Use.
Observe stability
The unit is nontilting in accordance with IEC regulations.
The following restrictions are applicable for accommoda-
tion of accessories:
Be sure not to exceed 30 kg maximum load-
bearing capacity of the stand.
If accessories which swivel to the front are positioned
on a column of the stand, e. g. on a swivel table, the
maximum load at this column is 5 kg.
Preparing
Stand
Accessories for oxygen therapy
Stability
9
Advertisement
Table of Contents
