Installing The Floor Mounting Brackets - Sun Microsystems StorEdge 3900 Installation Manual

7. Slide both stabilizer legs under the storage system.
8. Secure the leveling wrench inside the storage system.
9. Close the door.
10. If you are installing a Sun StorEdge 3900SL, 3960, 6960 or 6960SL storage system
with the second cabinet to be installed, proceed to Chapter 3 otherwise proceed to
Chapter 4.
2.6

Installing the Floor Mounting Brackets

Skip this section if you have installed the stabilizer legs and adjusted the leveling
pads in Section 2.4, "Adjusting the Leveling Pads" on page 2-3 and Section 2.5,
"Installing the Stabilizer Legs" on page 2-4.
Use the four floor-mounting brackets in place of the stabilizer legs if you want to
attach the storage system to the floor.
Caution – Do not bolt the floor mounting brackets to the deck plating of a raised
(computer-room) floor because this would result in an unstable mount.
Note – If you are installing the floor-mounting brackets over previously installed
threaded rods, you should loosely install the floor-mounting brackets to the rods
and then to the storage system.
Chapter 2 Installing the Storage Systems 2-7