Autoloader Components - Sun Microsystems StorEdge L280 Manual

2.1.3

Autoloader Components

2.1.3.1 Door
The door opens to allow access to the magazine. This door is locked by a solenoid
during normal operation and unlocked either from a front panel menu selection or
by pressing the Cancel button from three to five seconds. The door can also be
opened when the unit is powered down. The handle is removable by two screws.
2.1.3.2 Shelf
The shelf supports the Autoloader when it is rackmounted and comes with the
rackmount kit. The shelf provides incremental rack configuration flexibility.
2.1.3.3 Bezel
The bezel holds up the front of the shelf when the Autoloader is rackmounted. The
bezel comes with the rackmount kit.
2.1.3.4 Cosmetic Covering (Desktop Only)
The cosmetic covering protects the Autoloader during operation and shipment and
may be removed for rackmounting.
2.1.3.5 Standby (Power) Switch
The standby (power) switch is recessed behind a hole in the bottom left-hand corner
of the door. This switch can be accessed through the hole with a pen or pencil or
when the door is open. When open, a sheetmetal guard by the switch prevents
accidental switching during magazine insertion or removal. This switch turns off
power to the drive, fans, autoloader controller board, and display. See Section 2.1.8,
"Autoloader Electronic Connections," on page 2-7 for more information.
Caution – Power is not turned off to the transport controller and the transport.
2-2 StorEdge L280 Service Manual • February 1998