And Installation; Robe Cord Removal And Installation; Bear Seat Back Removal And Installation; Rear Seat Center Arm Rest Removal And Installation - Cadillac 54-6219 1954 Shop Manual

3-39
BODY
2. Remove screw and washer from both lower hanger plate to seat back support attachhg bolts.
corners of seat back panel and at lower center of
panel. 6. Disengage the top of the seat from under the
rear seat back valance and lift the seat back from
3. Behind lower corners of seat back panel re- the retaining hooks along the bottom.
move four seat back attaching screws from both
lower sides of seat back frame, and remove seat 7. To install, reverse the removal procedure
back. making certain that all attaching tabs and hooks
have industrial tape applied to them to act as an
4. To install, reverse removal procedure.
anti-squeak.
59 Robe Cord Removal
b. 6267
and Installation
1. Remove rear seat cushion.
a. 6219
2. Remove the lower seat back retaining screws
1. Remove both seat side panels as described in
and washers.
Note 52b.
3. Lift the rear seat back from the retaining
2. At both ends of robe cord, remove pin re-
hooks and remove seat back from the body.
taming robe cord to spring retainer and remove
robe cord from seat back. 4. To install, reverse above procedure, using
industrial tape on tabs and hooks to act as a anti-
3. To install, reverse removal procedure. squeak.
b. 6019 c. 6219, 6019
1. Remove the front seat backpanelasdescribed
1. Remove rear seat cushion.
in Note 58c.
2. Place the center arm rest in the half-down
2. Remove two assist handle screws.
position and disengage the upper ends of the center
arm rest filler panel from behind the rear seat
3. Pull assist handle away from finish panel, and
back.
detach robe cord from spring.
3. Remove the two center arm rest hanger plate
4. Repeat steps 2 and 3 to remove opposite assist to seat back support attaching bolts, working through
handle and other end of robe cord. the center arm rest opening.
5. To install, reverse this procedure. 4. Straighten the attaching tabs.
60
Rear Seat Back
5. Disengage the rear seat back from the attach-
Removal and Installation
ing
tabs and lift the
seat back to disengage it from
hooks.
a. 6237
6. To install, reverse the removal procedure
1. Remove rear seat cushion.
making certain
that
all attaching tabs and
hooks
have industrial tape applied to them to act as an
2. Working through the rear compartment open- anti-squeak.
ing,
remove the rear compartment front trim
foundation.
61 Rear Seat Center Arm Rest
Removal and Installation
3.
Bend
down the rear seat
back
upper retaming
tabs.
I. Remove rear seat back, Note 60.
4. Place the center arm rest in the
half..down
position and disengage the upper ends of the center
2. Remove the four center arm rest hanger
arm rest filler panel behind the rear seat back.
plate to seat back frame attaching screws and re
move the arm assembly.
S. Working through the seat back center arm
rest opening remove the
two
center arm rest 3. To install, reverse the removal procedure.