Horizontal Electric Regulator Removal And Installation; Vertical Electric Regulator - Cadillac 54-6219 1954 Shop Manual

3-37
BODY
and dieengunge hit fronn equalizing rod, Place a
sopporc under equalizing rod,
3, Relilove retsltting ring ''C'' and detach crank
Link from pun.
4, When removing right adjuster, rennove bolt
'D" from
rear
littk of right adjuster,
5, Remove seat adjuster to floor pan screws.
6. Pull adjuster outward to disetigagc' littk piti
.'E'' r±ert' vertical equalizing red end plate, theti
ralee equalizing rod to disengage it
from
iiui'a pin
''F'' suid to clear fhtnr plate flange ''0'', Reninve
adjuster,
7. To install adjoster. reverse rennaval proce
dure. Be sure that rubber washer is installed on
end ot horizontal equaiiz.ing rod, between red 'and
rod
support. When i;tsaIIing adjLuscer
to
floor pan
scrcwa. do not ttghreo screws LuaU seat bottotti
frame Irns boon secured to seat adlusters,
& As a bench operation, remove regulator to
support pin retaining rings and washers. Remove
supports frotti rnguletor.
1, To install,
reverse
above procedore,
55 Horizontal Electric Regulator
Removal and Installation
I, Operate
coat
to a raised end for,sord position.
2. Disconnect hnrl?.natal regulator leaC, wirea at
ctnnnector a
-
Under left side of seat on sedan models.
detach tensioner spring fracn equalizing rod.
S. Torn hack carpet, remove cegu tator floor pan
soppoct cover ''A'', Fig. 3,64, and remove suppect
sccews 'F'.
4, On sedan mrslels, detach horiznntal regulasr
seat frame support at front of seat, retoined by
bolts 'A'' Inset of Pig. 3-64. On coupes, remove
support screws ''As'. Pig, 3-65, retaining ring 'B'
seat rattrved for illusrattve purjxu.ses only and
remove
regulator.
56 Vertical aectric Regulator
Removal and Installation
I. Opcratc seat to a raised ant] fur'sarn poeition.
2. From under rear of seat, remove retaining
ring, Pig, '3-66.
3. Lower seat nnd detach vertical regulator head
wire cot,ncctors and ground wire.
4, Under front of ecat remove vertical regulator
floor pat, support
ecrews ''A''. Pig. 3-67, then
ca'-efully remove regulator irtumsupport pin at rear
of ac_ar See ''C'' and ''D'', Fig, 3-65.
5, Remove assembly front car and remove
Fig. 3-65 Hothantul Electric Pegualopor kennosni
Coopet
Fig. 3-64
Ho, izanto I El ctri c Re gui a tor
Rennw,o I
SedonO
Fig, 3-66 Vert i
cnl Rag ul
atat Retn mng Ring