Cadillac 54-6219 1954 Shop Manual page 314

14-29
HYDRA'TC DRIVE
Install reverse clotch release coil spriltg
retainer and ca"prcss
springs with Special Tool
No.
J -467cJ -A,
Pig, 14-17.
17. Install large snap ring, holding spring re
-
tamer in place.
IS, Remove Special Tool No. J-4670-A.
19. Check dowel pin height as shown in Fig,
14.45 Lay straight edge across reverse cone
clutch piston aitd niessure distance 1mm face or
straight edge
to
face of rear bearing housing.
'lijia djs';tne she-aId be .5 /'d'' to 13/32''
NO'l':
If the above meaaorement is less than
S/R'' the dowels are too short and he unit should
be replaced, I' I i.e greater than t 3/32
'',
dia
-
assemble the unit and press dowels in as far as
they can grI with an anhor press. Reaeeemhle the
tm it and remeasu re
-
If rho pin I'eight is still tan
great, replace lie rear hearing Ilausiog returner
and oil .seal
11/. Install hall bearing in rear bearing retainer.
Be sure that heariltg ts fully and squarely sea ted
by tapping genr:-y.
21. Install new large special type snap ring in
rear baaring rolainer locating haIl bcaring,
22. Install reverse internal ge.an and stationary
cone into rear bearing retainer by tur'apressing
stationary cone by hand,
,slrion keyway of
aratinnary cone so it will line up with kc:vway in
case when itlstahc& Fig. 14-46,
23, mace small spacc:r ovor output shaft.
24. Instail outpnt shaft in rear bearing huusing
FiG. 14-46 Imtallin Stotionry Cone
and mesh carrier gear with the reverse internal
gear,
Nl:lrb;:
he sure re-ar hearing is all the way
down or, the output shst
.
Snap
ring cannot he
installed until retainer is hilly seated,
25. Install roar bearing retainer sleeve over
output shaft at rear of housing 'md let it raIl dtlu
place.
26. install open type soap ring thrnugh window
in near bearing retainer, lackIng Ui-a ring retainer
sleeve
its
ball bearing. Sc sure sleenc ia between
snap ring amid bell bcnring
-
27, Install
cover with gasket over window on
rear
hearing retainer and tighten four screws
-
28, Install new rear oil scat using Oil Seal In'
sr-aller, Tool Nt,,
J
-1942-A, Pig
-
14-47
-
29, Install stadunary cone to case lock key, and
hold in place with 'metro Iat cm
30, Install speedometer driven gear.
,
øq-.-,
Fig. 4-45 Checidnç Daasl Pin Height
Fig, 4-47 lnrallin Estension Fla.ain0 Oil 5al