Removal And Installation Of Front Door Assembly - Cadillac 54-6219 1954 Shop Manual

3-il
be 1e rover is inst ailed, seal
plate at offset with medtotn
BODY
2. Appiy rihhon of mediom-bediad sealer to
lower side flanges of loading hole cover before
it ii installed Ihi s seal
ehooho extend upward
approximately three 3 inches.
3. Aftar loading
lower colliers of
hidied .ceaher
Fig. 3-l.
4. Apply water-proof tape over welding access
holes.
5. Apply water-proof t,,pe over cam ac.ce.ss
holes.
6, Seal ventileter division chamiel lower at
racIiiii hole with body raotking cempoond,
7. Apply water-proof tape
over
trim pad nail
attaching slots In inner panel en the lack pillar
side of the dtxir.
S. Apply a riBbon of medittm-bodied sealer
aloog the c.ontae:ing surface of door io:,er pstuel
coniplotely around access hole.
9, litter
to ossemhhy of
door iuearet
duct, apply a rIbbon of mediuta-hedied
completely around surface of oothet dtict
contacting doer inner panel.
Ii On sedans
,'eeeed Cs lLows:
Apply hoey eat,hkmnur compound to seal heater
duct attaching holes.
Apply caulking cttmlxicnd to wiring chip, station
-
amy cain rod regulator teat
attaching holes.
Apply rar'e over arm rest attaching holes.
Apply tape over trim pod oait slots at deer lock
ootlet
sealer
gaskel
II, it, ceopes. proceed a.e follows;
Apply eaohking compound to window regulator,
hester duel, wiring clip and stationary cam attach
ing screws.
Ap1 y water -proof tape over attn rest attaching
holes, lower gage hole at
0th pillar end trim
pad naul .shots.
16
Removal and Installation of
Front Door Assembly
n, Removal
Tite door soil hi ages may be removed as in
assembly fretii the fromtt body hinge pillar, Cr he
door may he remov&h from the hinge straps.
2, llace soitahia protective covering over front
fender at door opening to protect finish.
3. Remove door tiLt', pad and door heater duct.
NOTE The above arep dne.c not have to be
porfornied if deer and hinges are being rc,'roved
and body is not eciriopod with powered mogul orote.
4, Scribe hInge box locations ott front body hinge
puhar er lomEge strap locations on door, depending
en what method of retioval is hoitig used,
.,.
if deer and hinge are being removed, remove
hinge cover attaching screw and doom attaching
bolt, Fig, 3-16, from upper itinge and remove
covet.
Pig, 3-il
Doe, Innet
Pooui SeaLiog
pillar.
fig. 3-16 emoving Ooou Hinge Covet