Cadillac 54-6219 1954 Shop Manual page 199

10-32
ENGINE MECHANICAL
7. Connect windshield wiper vacuum hoses to
manifold vacuum line and vacuum Øump line.
8. Connect yellow and black wires to porcelain
resistor.
9. Connect ground straps, primary wire to dis
tributor, oil pressure and cooling system tempera
ture switch wires.
10.
Connect flexible fuel line
to
fuel pump.
11. Install carburetor, connect carburetor link
-
ages and fittings and install carburetor air cleaner.
12.
Connect power brake vacuum line ofi
Cars
so equipped at intake manifold.
13.
Install radiator core.
14. Install tipper and lower radiator hoses.
15.
Connect refrigerant lines as explained in
Section 16a, Note 13b,
on cars equipped with Air
Conditioning.
16. Connect power steering pump
to
valve
body
hoses and fill
tank to proper
level with Hydra-Matic
Transmission fluid.
17.
Connect wires to generator.
18. Install hood top panel and align
to
cowl and
fenders.
19. Connect battery cables.
20.
Raise
front of
car and install stands.
21. Connect speedotncter cable and shift linkage
at transmission.
22, Install transmission linkage slush deflector.
23. Install starter on engine.
24, Using new gaskets, connect right and left
exhaust pipes
to
manifolds.
25. Adjust hand brake cable at relay.
26.
Install idler arm support in position
on
right frame side bar.
27, Tighten front engine support nuts to 80-90
foot pounds torque.
28. Fill cooling system, crankcase, and trans
mission.
29. Adjust throttle control linkage, as explained
in Section 14, Note 4.
30,
Set ignition timing and check operation of
car.
OTHER NOTES AND REFERENCES