Cadillac 54-6219 1954 Shop Manual page 401

16-E-46
AUTRONIC EYE
heck refiections from the headlamps of the car
on
which the Autronic Eye a installed will hold
the
lamps on the lowr beam. Also, the unit must
be almedas iow as possible to provide the maxi
mum tolerance for car loading
4. Turn headianips
ON!
and wait at least four
minutes for amplifier In stabilize. Setstandnrdfoot
dimmer switch to
]Automatic! position. Upper
beam wiil then be on.
5, Turn zero corrector on face of meter untii
meter pointer is oi zero set line, rig. 16E-4.
6. Turn the intensity ritcostat all the way counter
clockwise, Fig. 16R-3,
7. Turn the selector s'stch to Its !DIM! posi
loll.
3
Sensitivity Adiustments
0.
"DIM" Sensitivily Adjustment
CAUTION:
The Auttonic Eye develops 1U
volts
- -
headlamps must be turned off before
removing cover from phototube unit
1. Remove two ova i head screws from bottom of
the phototube unit.
2 tAft off
cover,
remove lens and replace lens
with test amp. Fig, 16E-3.
3. Replace cover and screws
NOTE: Re
sure to
use corruct
DIM! posi
-
tion for clear or tinted winmhshieids.
g. insert the eonnectot Into the cigar lighter
receptacle. Soil Tester only.
.
Check car battery voltage, If
volts, operate engine at fast idle
sensitivity adjtmsu1isnt.
It. Turn intensity rhstat clockwise slowly
just to the point where ha Imeadlamnps swdteh to the
lower beam. The meter pointer should fall within
ube !DTM!* sensitivity ad justment line. Pig. I6E-5.
less than 12
when snaking
F i
.
i6_ [-4 Meter
Z.F&
ng Bottod
Fig. 6 E-2 Level' n9 Ad jutirneni
Fig.
6- E3 SeFait
ivi ly
Mj mtne,,t la. I6--5
Dir.,
Sensitivity Meter