Output Configuration - BEA LZR-FLATSCAN 3D SW User Manual

Safety sensor for automatic swing doors. for software version sw 0100 and higher
Table of Contents

Advertisement

OUTPUT
CONFIGURATION
UNCOVERED ZONE
BACKGROUND /
ANTIMASKING
SAFETY FIELD DEPTH
OPENING FIELD *
* only available with the
new BEA remote control.
OPERATING MODE
FACTORY VALUE
R1
R2
R3
NO
(Normally open)
(Normally closed)
NC
In order to change these settings by remote control, adjust DIP-switch 2 to ON.
2
Increase in case of snow, dead leaves, etc.
* measured in specific conditions and dependant on application and installation.
In order to change these settings by remote control, adjust DIP-switch 3 to ON.
OFF
ANTIMASKING
OFF
BACKGROUND
Antimasking: protective function which detects an unwanted object nearby the laser window masking the vision
field. Background: reference point in the detection field of the sensor. If no background is present, switch to off.
1 curtain
REOPEN side: During the opening cycle, the sensor always extends the safety depth up to 4
curtains to cover the whole door pathway.
OFF
1 curtain
STATIC
AUTO - The Flatscan, when operating, is
in dynamic operation when using two interconnected modules
in static operation when using a single module
In dynamic operation, the Flatscan dynamically adapts its detection fields according to the door
position to fit the environment. An expanded field and wall masking are possible.
In static operation, the detection field remains unchanged regardless of the door position. If opening
against a wall, the door controller must be set accordingly to ignore it.
STATIC - This mode can be chosen to force static operation.
MAN. - This mode is used for manually operated automatic doors. The Flatscan is in dynamic operation
and the reopening and opening signals are set on the hinge zone while the door is closing. Two modules
must be interconnected to use this mode.
Always enter 3 digits for output parameters:
- 1st digit refers to the Output 1 (R1)
- 2nd digit refers to the Output 2 (R2)
- 3rd digit refers to the Output 3 (R3).
6
4
8
OFF
ON
ON
ON
OFF
ON
2 curtains
2 curtains
AUTO
FLATSCAN 3D
NO
NO POWER
NO DETECTION
DETECTION
10
12
14
3 curtains
4 curtains
3 curtains
4 curtains
MAN.
SW
NC
cm*
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lzr-flatscan sw

Table of Contents