Configuring Using The Front Panel; Configuring The Sensor - Wavetronix Click 65 Series User Manual

Click 65x User Guide
8
•

Configuring using the front panel

Select Network Setup from the main menu using the keypad.
1
Enter an IP address, subnet mask, and default gateway for the
2
local network. Make note of the IP address for further configura-
tion later.
If desired, select Utilities >> Display Off to set the amount of
3
inactivity on the main OLED panel display before it shuts off.

Configuring the sensor

Attach a laptop, tablet, or other device capable of running
1
SmartSensor Manager to the Click 65x. (Attachment can be
done through the local network if an IP address and other net-
work information has been properly set on the device, and an
Ethernet cable has connected the Click 65x to a local network
switch or router. Attachment of a configuration device can also
be done through the RS-232, RS-485, mini-USB, or T-bus ports
on the front panel).
Use the appropriate version of SmartSensor Manager to con-
2
nect to each sensor:
Matrix – For Matrix sensors, connect using the Internet tab
̀
with the IP address of the Click 65x unit, default port 10001.
If more than one Matrix sensor is attached to the Click 65x,
each sensor should appear in the list.
Figure 2. SmartSensor Manager Matrix