Adding Multiple Sensor Channels - Wavetronix Click 65 Series User Manual

Click 65x User Guide
30
•
Not all detector channels need to be assigned. To leave a detector
channel unassigned, set the Sensor Selection and Sensor Chan-
nel columns blank ("---"). Detector channels do not need to be
assigned in order—any of the available detector channels can be
assigned or left blank depending on your preference. The same
sensor channel can also be assigned to multiple detector chan-
nels, even across different BIUs.

Adding multiple sensor channels

The Click 65x supports combining multiple sensor channels
together into one detector channel output. To do so:
Click the + button on the right side of the grid and the grid entry
1
will open up displaying additional rows of UI fields (see the
figure below).
Figure 19. Adding multiple sensor channels
The channel entry can now register two or more devices tied
2
together into one channel output. For each entry, select a
sensor from the middle column, and a sensor channel.
To add more than two sensor channels, click the + button again
3
to add a new row. To remove the bottom-most sensor entry, push
the - button in the last column to delete it. The Click 65x can sup-
port up to 12 sensor channels assigned to a detector channel.