Configuring Using The Web Interface; Using The Properties Tab; Using The Sensors Tab - Wavetronix Click 65 Series User Manual

Note. If the IP
address or other
network information
needs adjusting, you
can do that on this
page. Click Save
when finished, and
the web interface
will automatically
adjust to use the
new IP address.
Note. If desired, you
can enter a name for
each sensor in the
Name field. (These
names are used
for convenience
within the Click
65x for channel
configuration.).
Click 65x User Guide
10
•

Configuring using the web interface

Open a web browser on the connected laptop or tablet.
1
Type the Click 65x IP address into the browser's URL field. The
2
Click 65x web interface should load.

Using the PROPERTIES tab

Select the PROPERTIES tab at the top of the screen and enter
1
a name, location, and description for the Click 65x.
For each BIU number you want the Click 65x to respond to,
2
click the checkbox next to the number. Leave unused BIU num-
bers unchecked to avoid controller conflicts with other cabinet
devices.
Make sure that the sensor numbers for all ports with sensors
3
attached are checked.
Click Save Device Properites.
4

Using the SENSORS tab

Select the SENSORS tab at the top of the screen.
1
To discover Matrix sensors, check Matrix Full Search, click
̀
Discover Matrix Sensors, and wait until the "Discovering
sensors, please wait..." message stops flashing.
To discover Advance or Advance Extended Range sensors,
̀
click Discover Advance Sensors and wait until the discovery
process completes. (This will typically take longer than Matrix
discovery.)
Discovered sensors should be listed in the web page. If a
2
sensor does not appear in the list, make sure it is powered
and connected to the back of the Click 65x, and make sure no
Figure 4. Click 65x web interface