There are four main steps for installing and using the Click 65x:
Installation
1
Front panel configuration
2
Sensor configuration
3
Web configuration
4
Installing the Click 65x
Place the Click 65x in the traffic cabinet. They are designed to
1
be shelf-mounted, but can also be mounted to the cabinet wall
using U-channel mounting brackets.
Connect one to six sensors to the connectors on the back of the
2
Click 65x. Make note of which sensor port is used for each sensor.
Power on the unit using the switch on the back. The OLED
3
panel will activate and display the initial loading screen.
Power all connected sensors by toggling the appropriate switch
4
on the front of the Click 65x. Each switch has a corresponding
green LED to indicate whether the sensor is powered or not.
Connect communication cables (Ethernet, SDLC, and/or contact
5
closure RS-485 outputs) into their respective ports on the front
of the device.
Quick Start Guide
1
Note. There is a
19-inch rack shelf
option available
for purchase.
Chapter 1: Quick Start Guide
7
•