Sensors Tab - Wavetronix Click 65 Series User Manual

Enable Sensor Data Port – These checkboxes activate or
˿
deactivate the respective sensor port for communication. Ports
with a sensor attached need to be activated before sensor
events will be transmitted by the Click 65x. Ports without a
sensor attached can remain deactivated.
Click the Save button to save any modifications to these fields.

Sensors tab

The Sensors tab is used to discover sensors connected to the
Cick 65x device and add location information. Use the steps below
to discover sensors and add descriptive information about each
device:
Complete sensor configuration before Click 65x discovery.
1
During discovery, the device saves the current sensor channel
configuration for use in channel mappings. Subsequent changes
to sensor configuration will not automatically be updated within
the Click 65x; sensors will need to be rediscovered on this page
before the web interface will reflect the new changes.
Before adding sensors through the web interface, make sure the
2
sensors are connected to the proper port on the back of the unit.
Turn on the power switch on the front of the Click 65x.
3
Click the Discover Matrix Sensors and/or Discover Advance
4
Sensors buttons and the system will automatically query all
data ports for each type of device and display any discovered
device to the screen. Use the Matrix Full Search checkbox if
this is the first time connecting to this device.
Figure 17. Sensors tab
Note. Since the
web interface URL
uses the device IP
address, if the IP
address is changed,
the web interface will
automatically redirect
to use the new IP
address, allowing
you to continue using
the web interface
uninterrupted.
Depending on the
browser type, this
redirection may
trigger a dialog box
asking for approval
beforehand.
Note. When the
Click 65x is being
configured for the
first time, this screen
will be empty, as no
sensors have yet
been discovered
and registered.
Chapter 4: Web Interface
27
•