Table of Contents
Advertisement
Connect the wire feeder to power source as follows:
1.
Connect the welding cable between the plus pole of the power source and the cable
connector on the backside of the wire feeder.
2.
Connect the control cable between the power source and the wire feeder (the
connectors are on the backside of the machines).
3.
Connect the shielding gas hose between the gas cylinder and the wire feeder (the
connector is on the backside of the wire feeder).
2.2
MagTrac F 61 connections
Attach the welding power cable to the Euro connector and the control cable to the data
connector either in the wire feeder unit or in Kemppi SuperSnake subfeeder. See the pictures
below.
To connect the welding gun to MagTrac device:
The MagTrac F 61 is equipped with Kemppi's unique welding gun quick-fixing mechanism.
1.
Loosen the slide block fixing screw (1) and open it a few rounds so that the slide block (2)
comes out.
2.
Put the welding gun into the slot and replace the slide block.
3.
Tighten the gun into its place using the fixing screw.
4.
Attach the control cable to the bus connector on the carriage.
© Kemppi Oy / R01
1.
2.
EN
5
Advertisement
Table of Contents
