Safety; Important Safeguards; Label Symbols - ETC F-Drive R12 Series Installation Manual

Safety

The F-Drive Series R12 is intended for professional use only. Read the entire manual before
using this equipment.
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed
including the following:
•
•
•
•
•
•
•
•
•
SAVE THESE INSTRUCTIONS
Note:
information about maximum number of four-pair cables in a bundle, see NFPA 70 2020
National Electrical Code, table 725.144.

Label Symbols

R12 Drivers are conveniently labeled with relevant symbols for your safety. Refer to the product
label to see which symbols apply to your product.
General warning
This product should not be discarded as unsorted
waste but must be sent to separate collection
facilities for recovery and recycling.
The product input or output is suitable for direct
current only.
Safety extra low voltage device
Protective earth (ground)
4
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS.
Do not use outdoors.
Do not let power supply cords touch hot surfaces.
Do not mount near gas or electric heaters.
Equipment should be mounted in locations and at heights where it will not
readily be subjected to tampering by unauthorized personnel.
The use of accessory equipment not recommended by the manufacturer may
cause an unsafe condition.
Do not use this equipment for other than intended use.
To reduce the risk of fire and overheating, make sure all connections are tight.
Turn off electrical power before modifying the lighting system in any way.
Cable bundling limitations apply to F-Drive R12 Class 2 output cables. For more
Avertissement général
Ce produit ne doit pas être jeté avec les déchets
ménagers mais doit être déposé dans une collecte de
déchets électroniques ou dans un point de collecte.
L'entrée et la sortie de ce produit convient
uniquement au courant continu.
Dispositif de sécurité à très basse tension
Protection Classe I Mise à la terre
R12 Installation Manual