Channel Configuration, Data, And Status; Section 4.1 Configuring Each Input Channel - Spectrum Controls SLC 500 User Manual

Counter/flowmeter input module
Hide thumbs Also See for SLC 500:
Table of Contents

Advertisement

Section 4.1
Configuring Each
Input Channel
User's Manual Pub. 0300181-07 Rev. A
Configuration, Data, and Status
Read this chapter to:
Configure each input channel.
Set user-defined scale limits.
Monitor each input channel.
Check each output channel's configuration and status.
The Data Register format uses Class 3 operation. Class 3 mode allows the
module to use 32 input words and 32 output words of data, as listed below. After
installing your module, you must configure each channel by setting bit values in
each configuration word. Output words 0 through 31 of the output image file,
(addresses O:e.0 – O:e.31), configure channels 0-7 respectively and (addresses
O:e.0 - O:e.15) for channels 0 - 3 of the CTR4.
Channel

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SLC 500 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

1746sc-ctr4746sc-ctr8

Table of Contents