2-4
Chapter 2: Installation and Wiring
User's Manual Pub. 0300181-07 Rev. A
When inserting your module into the rack, you do not need to remove the
supplied terminal block from the module. If, however, you do remove the
terminal block, apply the supplied write-on label to the terminal block, and use
the write-on label to identify your module's location and type:
To remove the terminal block, unscrew the two retaining screws at the top and
bottom of the terminal block, and using a screwdriver or needle-nose pliers,
carefully pry the terminal block loose.
Need help?
Do you have a question about the SLC 500 and is the answer not in the manual?