Block - Spectrum Controls SLC 500 User Manual

Counter/flowmeter input module
Hide thumbs Also See for SLC 500:
Table of Contents

Advertisement

NOTE
NOTE
Section 2.9
Labeling and Re-Installing
the Terminal Block
IMPORTANT: Channels 4-7 are only available on the 1746sc-CTR8
module.
IMPORTANT: A pull-up resistor may be necessary for open collector
inputs. Refer to Chapter 6 for additional information.
The supplied label is mounted on the module door. This label helps ensure that
the terminal block is wired correctly for the module.
Once you have wired your module and properly labeled install the terminal block
on your module:
1. Align the terminal block with the receptacle.
2. Insert the terminal block and press firmly at the top and bottom until it is
properly seated.
3. Screw in the two retaining screws on the top and bottom of the terminal

block.

Chapter 2: Installation and Wiring
User's Manual Pub. 0300181-07 Rev. A
2-9

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SLC 500 and is the answer not in the manual?

This manual is also suitable for:

1746sc-ctr4746sc-ctr8

Table of Contents