Chapter 4 Module Data, Status, And Channel Configuration; Section 4.1 Module Memory Map - Spectrum Controls 1769 Series User Manual

6 channel isolated thermocouple/mv input module
Hide thumbs Also See for 1769 Series:
Table of Contents

Advertisement

Section 4.1
Module
Memory Map
User's Manual Pub. 0300244-01 Rev. A
Chapter 4
Module Data, Status, and
Channel Configuration
After installing the 1769sc-IT6I Isolated Thermocouple/mV Input Module, you must
configure it for operation, usually using the programming software compatible with the
controller (for example, RSLogix 500 or RSLogix 5000). Once configuration is complete
and reflected in the ladder logic, you need to operate the module and verify its
configuration.
This chapter contains information on the following:
Module memory map
Configuring channels
Accessing input image file data
The module uses eight input words for data and status bits (input image), and seven
configuration
words.
Slot e
Input Image
File
Slot e
Configuration
File
Input Image
8 words
General/Open-circuit Status
Over/Under Range Status Bits
Channel 0 Configuration Word
Configuration
Channel 1 Configuration Word
File
Channel 2 Configuration Word
16 Words
Channel 3 Configuration Word
Channel 4 Configuration Word
Channel 5 Configuration Word
Memory Map
Channel 0 Data Word
Word 0
Channel 1 Data Word
Word 1
Channel 2 Data Word
Word 2
Channel 3 Data Word
Word 3
Channel 4 Data Word
Word 4
Channel 5 Data Word
Word 5
Word 6
Bits
Word 7
Word 0
Word 1
Word 2
Word 3
Word 4
Word 5
Not Used
Word 6
Not Used
Word 7
Not Used
Word 8
Not Used
Word 9
Not Used
Word 10
Not Used
Word 11
Not Used
Word 12
Not Used
Word 13
Not Used
Word 14
Not Used
Word 15

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 1769 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

1769sc-it6i

Table of Contents